Brass Push-Fit Tee Fittings, 1/2 Inch, 12 Piece Kit with Removal Tool

Twelve half-inch brass push-fit tees with a pipe removal tool included. Push the pipe in until it seats and the fitting grips and seals itself. No crimping, no clamps, no torch, no glue.

Solid lead-free brass, corrosion resistant. Rated to 100 psi and 180 degrees Fahrenheit. Works with PEX, copper, and CPVC, so you can tie into an existing copper line without soldering.

Good for repairs in tight spots where you cannot get a crimp tool in, and for anyone who would rather not solder. The removal tool lets you release a fitting and reuse it.

For hot and cold water lines, hydronic heating, and shower and faucet supply runs. Cut the pipe square and deburr it before you push, or the o-ring will not seal.

Not for gas. These are water fittings only.