Brass Push-Fit Pipe Fittings, 1/2 Inch — 25 Piece Kit, Straights, Elbows & Tees

A 25-piece push-fit kit in 1/2 inch: ten straight couplings, ten elbows, five tees, and a removal tool so you can pull a fitting back off and use it again.

Solid lead-free brass. Works on PEX, copper, and CPVC — same fitting, three kinds of pipe, which is why these are handy to carry.

Push the pipe in until it seats. That's the whole install. No torch, no glue, no crimp ring, no clamps. If you've never soldered a joint in your life you can still make these up right.

Rated to 100 PSI and 180 degrees Fahrenheit. Good for hot and cold supply lines, heating loops, shower risers, and outdoor hose runs.

Water only. These are not for gas.

Cut the pipe square and deburr it before you push — a ragged edge will chew the O-ring and you'll be chasing a weep you didn't need to have.