Square Handheld Shower Head, High Pressure — Black, Gray and Silver

A square handheld shower head that attaches to a standard shower hose and gives you a strong, focused spray with the freedom to aim it where you need it.

Built from ABS with an electroplated finish, it is designed for high pressure and a clean modern look. Available in Black, Gray, and Silver to match the rest of your bathroom.

Three spray settings: a concentrated jet with real force behind it, a fine mist, and a soft rain flow for a gentler rinse. Twist the face to change between them.

Installation

Five-minute job. No tools required, though an adjustable wrench and thread seal tape are handy if an old connection is stuck or weeping.

1. Shut off the shower and unscrew the old handheld from the end of the hose, turning counterclockwise.
2. Check that the rubber washer is sitting flat inside the nut on the hose end. This washer is what makes the seal, so if it is missing or cracked, replace it before you go further.
3. Thread the new handheld onto the hose by hand and turn until snug. Hand-tight is enough on a hose connection.
4. Turn the water on and check the joint. If it weeps, back it off, reseat the washer, and snug it again. Add two or three wraps of thread seal tape only if the weeping continues.
5. Hang it in the existing cradle or slide bar.

If you are also replacing the hose, the same washer-and-hand-tight rule applies at the shower arm end. Do not put a wrench on plastic threads.

Use and care

Twist the face to cycle through the spray settings. Rub the rubber nozzles with your thumb every few weeks to break loose mineral buildup before it blocks them. For heavier scale, unthread the head, soak it in white vinegar for an hour, then rinse. Do not use abrasive pads or bleach on the finish.

Handheld sprayer only. Valve, shower arm and hose are not included.