Water Heater Connector Kit — 3/4 Inch Braided Supply Line with Push-Fit Ball Valve
Water Heater Connector Kit — 3/4 Inch Braided Supply Line with Push-Fit Ball Valve
A braided supply line for a water heater with a push-fit ball valve built into the connector, so you get a shutoff right at the tank without adding a separate valve to the run.
The hose is 304 stainless steel braid over the inner line, with a lead-free brass valve body. The push-to-connect end goes onto copper, PEX, PE-RT or CPVC — push the pipe in and it locks, no soldering, no crimping, no glue. A disconnect clip comes with it for taking the connector back off, and the clip is reusable.
Rated to 200 psi and 200 degrees Fahrenheit, which covers hot water service on any residential heater.
Specifications
- Size: 3/4″
- Hose: Braided 304 stainless steel
- Valve: Lead-free brass ball valve, push-fit
- Compatible pipe: Copper, PEX, PE-RT, CPVC
- Maximum pressure: 200 psi
- Maximum temperature: 200 degrees Fahrenheit
- Includes: Disconnect clip
Not for gas.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.